0
Good day All,
DM800se
clone (sunray SR4 D6 with wifi)
SIM2.10
2nd Failed - Boot no ca found
I received a replacement motherboard from the vendor for my dead box and powered it on with old my SIM it is saying (in red) 2nd Failed?. It shows a picture of a processor with an x through it beside a usb stick then says “boot no ca found”
I have connected the USB mini cable & lan cable and able to communicate with the box.
Dreamup/sunray connects but it hangs with the message “upload completed waiting for acknowledge” after sending the flash loader;
Optiflasher managed to send flashloader and put box in http flash mode with fixed IP (192.168.1.77) and I managed to upload image and SSL via the browser, reboot button does not work but manual reboot takes me back to the 2nd failed, no ca state.
Info screen on the Http page is mostly blank see attachment
NCF connects and makes the box boot into the image (the one I loaded) but a reboot brings back the 2nd failed no ca error.
Also when the box boots with whichever image including my backups it does not recognize the 801A RevM tuner.
Could my Sim be bad? if the sim is bad is the tuner nor recognized?
Is there a way to check the sim?
Appreciate your expert advise!
DM800se
clone (sunray SR4 D6 with wifi)
SIM2.10
2nd Failed - Boot no ca found
I received a replacement motherboard from the vendor for my dead box and powered it on with old my SIM it is saying (in red) 2nd Failed?. It shows a picture of a processor with an x through it beside a usb stick then says “boot no ca found”
I have connected the USB mini cable & lan cable and able to communicate with the box.
Dreamup/sunray connects but it hangs with the message “upload completed waiting for acknowledge” after sending the flash loader;
Optiflasher managed to send flashloader and put box in http flash mode with fixed IP (192.168.1.77) and I managed to upload image and SSL via the browser, reboot button does not work but manual reboot takes me back to the 2nd failed, no ca state.
Info screen on the Http page is mostly blank see attachment
NCF connects and makes the box boot into the image (the one I loaded) but a reboot brings back the 2nd failed no ca error.
Also when the box boots with whichever image including my backups it does not recognize the 801A RevM tuner.
Could my Sim be bad? if the sim is bad is the tuner nor recognized?
Is there a way to check the sim?
Appreciate your expert advise!
