0
I have;
-DM800se
-Clone
-SIM2.01-ssl84b
-No Ca Found After Flash image
I am working with Optiflaher Pro v 2009;
This is how I do the job;
advanced > settings > V smart check NFI + use RS232/USB mode only
Enigma2 > repair [no ca found]
do job
This is how the progam ends;
i tried waiting for 1 minute til 1 hour but gives always the same result.
When I reboot the box, he says "no ca found"
What do I wrong or is there a other solution?
Regards
-DM800se
-Clone
-SIM2.01-ssl84b
-No Ca Found After Flash image
I am working with Optiflaher Pro v 2009;
This is how I do the job;
advanced > settings > V smart check NFI + use RS232/USB mode only
Enigma2 > repair [no ca found]
do job
This is how the progam ends;
i tried waiting for 1 minute til 1 hour but gives always the same result.
When I reboot the box, he says "no ca found"
What do I wrong or is there a other solution?
Regards