[frank087234]

0

I flashed the wrong (orginal) image on my dm800 (clone) sim 2.01
I used opti flash , connecting to com1 usb to serial, but and follw step, but nothing happened when I turn the dm800 ON.
I tested the usb/serial cable on another dm800 , no problem

Please help

[frank087234]

0

I followed the steps, but no response from box
"Power ON DB Device [ESC to Abort]"
the device is power ON, but nothing happened, the LCD panel show same error

---

Please note I flashed dm800 with original balckhole ssl84, then got the error
the boatloader which was working on the device is ssl82
Did I miss up the boatloader??

[frank087234]

0

OptiFlasher must have a response in all cases of software issue !
if not there's something wrong with comunication or cable !

I have tested the cables on another device, and it was recognised easily by optiflasher.
with faulty device nothing happenes!! any ideas??

[fairbird]

0

give info from hyper terminal.. see here
[Only registered and activated users can see links You are not allowed to view links. Register or Login to view.]

[frank087234]

0

nothing hyperteminal is connected, but Blank Page

[fairbird]

0

In this case as Yassinov said you have connection problem,
1-Try another pc another windows.
2-Try another cable.

[frank087234]

0

ok
I have another Box with Ferrari sim (Broken box got sim2.01), it is working fine. Is there anything else I can try using the working box to test? I tested the cables on it, and the yassinov softawre see the good box, but not the broken one.

[frank087234]

0

where is the expert yassin????

[fairbird]

0

Not clear...
please make it more clear mhat you mean?
Did you change sim Ferrari with sim2.01 or you put sim2.01 in Ferrari box ?

[frank087234]

0

I put sim2.01 in Ferrari box ? showed erro1 no ca found
then change Ferrari sim in the sim2 box, showed erro1 no ca found.