[fairbird]

0

Ok...If the third proposal also does not work..Put here the error that appears in the front border ..

[morteza]

0

the third part was sent with optiflasher no lan serial port


Power ON DB Device [ESC to Abort]
DM800HD Detected !
Dreambox Detected...Ok!
Sending Flash Loader...
Second Stage OK!
Boot Success & Ready For Job Process!
Name: Merlin-3-dm800-11-19-ramiMAHER.nfi
FSize: 42112288 bytes
Authorization id: 5DBA0418
Flashing IMAGE Phase1...
Finalizing Job Phase2...Please Wait...
Dreambox Flashed Successfully !

but after the reboot the box says error! in lcd

---

what a hell is wrong with this box?

[fairbird]

0

I told you if does not succeed, Put exactly the error that appears in the front border ..

[morteza]

0

that is it
when the box comes on it shows Dream Multimedia
-> error!
and the red light keeps blinking

[fairbird]

0

Ops....you never mentioned this error.
Cause of this problem if motherboard does not connected with sim card, maybe sim was Corrupted or not install in the right place...
It can be a difficult problem.
So the soultion:
My advice..
1. Make sure the simcard properly sits into the holder.
2. Check the contacts, clean it.
3. Or flash that image and you press the SIM Card.
probably the simcard is defective, replace or try to repair it with a card reader.

[morteza]

0

HI
i dont think is the sim card with the other sim (original) i get the same error
i have a simcard reader (omnikey) the simcard dosent go in because the head of it is thick.
i think my problem is hardware problem when the box trys to boot it checks every part to come up,it looks like it stops on checking a faulty part and gives the error.

[fairbird]

0

Here picture and some description from some friend..Thank you "Johnny-burrp"

Howto measure pin 1 (DC volt measurement).
And about original sim..How to put sim and how to flash image..Tell me how you did? put the sim first, or flash org. image?

[morteza]

0

HI
i put the sim in first then flash with original image

[fairbird]

0

It was wrong way...
Do this steps:
1.Put old sim.
2.Use opiflasher.
2.Flash Last SSLxx for original image.
3.Unplug box.
4.Flash any new original image. I recommend you the first time this image
[Only registered and activated users can see links You are not allowed to view links. Register or Login to view.]
5.Unplug box.
6.Change sim to original.
7.Plug box again.
This is right way to change and replace sim.
If your box booting fine so congratulation. If not take your box to technical to make test and chack sim area and motherboard.

[stigmata1823]

0

im having the same problems here guys