[traxtrax]

0

Hello everyone,

Here some quick details:
-DM800HD
-Clone
-SIM2.01 (says below box, golden sticker)
-No Ca Found After Flash image

I have been trying to solve this issue for a few days but no luck yet.
I tried to flash my bootloader but apparently my DM800HD was a clone.. (I opened the box itself and compared with wiki, and it seems to be a clone, couldnt tell from the outside)

So now I am getting the No Ca Found error.
I have a null modem cable, PC has a COM1 port, Lan cable, router.

Now I tried Optiflasher, I have connected the null modem cable from receiver to PC, Lan cable from receiver to router

DCC can connect to my receiver, FTP OK and TELNET OK but when using Optiflasher I close DCC.

Optiflasher can connect to receiver, status says: Connected
I selected COM1 port and LD1 and I also selected Repair [NO CA FOUND]

When I click on Do Job, I get a message, Power on DB Device [ESC to Abort]
But the DB receirver is already on!
And optiflasher stays at Busy 0%.... I am not getting any error in optiflasher but nothing happens.

My old Bootloader was 76A
I wanted to install bootloader 84D
My DM800HD has SIM2.01

Please let me know if you could help me out or if you need any more information

Thanks a lot!

[traxtrax]

0

Thanks for your reply!

I want to a Turkisch sattelite store and they restored it for me.
I now have ssl84B.. thats what the box is showing when I put it in STOP/BOOT mode.
Is it possible?

But now the new problem is: It cant find a Tuner.
The tuner is empty.
Is it because the software is wrong? its using OpenPLI
But I dont know if its patched or not.

Thanks for helping me.