[Nudel]

0

Hi.

I recently bought a 800HD PVR.
I could connect to it via FTP.
But I wanted to upgrade it.

So I searched for a few hours and found a recommended bootloader
I flashed it via HTTP with no problems.
But when I started it up later, I had the NO CA error.
Well, no problems there. But i learned that I had bought a clone...

I then searched some more and found that this setup would work;
sim201_ssl84a
OpenPli-3.0-hdglass16-8.55-DM800-SIM2-SSL84D-26.10.2014-Houara

So I connected the box with both the rs232 and LAN cable.
No problems there eather.
Box connected. Said it was a DM800 down the corner in Dreamup.

I then flashed the bootloader.
And I also flashed the PLI image through Dreamup.

But after 99% of installation I got a error message.
"Error - box will be useless now"

Didnt thought much more of that. But I discoennected the box.
And now it is impossible to connect to it.
I have tried every single program to connect to it, but nothing.

When i put in the power cable the ethernet connector lights up.
But it is impossible to start it.

I have disconnected the tuner.
I have removed the SIM.


How do I fix this box?

SIM 2.01