0
Hi,not quite sure why it worked but i fixed it.
I connected ethernet and null cable to the powered off box.
I then started the COM Port Stress Test software i downloaded and that displayed data going out from the pc but nothing coming back from the box.
With the software still running i powered on the box whilst holding the power button down and voila,the port tester software showed data going to and most importantly "from the box" and the ca error on the front display had changed to the correct serial port message complete with ip address.
Could have been coincidence but i did try it again without the software running and the fault returned.
Didn't need to use dreamup or any other software just a new image.
I then went online and updated the image in the usual way and it's been faultless since.
Well happy.
I connected ethernet and null cable to the powered off box.
I then started the COM Port Stress Test software i downloaded and that displayed data going out from the pc but nothing coming back from the box.
With the software still running i powered on the box whilst holding the power button down and voila,the port tester software showed data going to and most importantly "from the box" and the ca error on the front display had changed to the correct serial port message complete with ip address.
Could have been coincidence but i did try it again without the software running and the fault returned.
Didn't need to use dreamup or any other software just a new image.
I then went online and updated the image in the usual way and it's been faultless since.
Well happy.
