03-31-2014, 05:51 PM
0
I have been trying to connect this dm800 with sim 2.10 to dreamup all day but could not get a connection. I used hyperterminal but could not get a good read out with baud rates at 115200 or 57600 but it will read normally at 38400.
Is it possible to flash using hyperterminal or change the baud rate on the dm800? The no CA tool uses 115200 or 57600. Dreamup uses 115200.
I also tried an old sim 2.0 but with the same results
Any other ideas for this.
Thanks
Is it possible to flash using hyperterminal or change the baud rate on the dm800? The no CA tool uses 115200 or 57600. Dreamup uses 115200.
I also tried an old sim 2.0 but with the same results
Any other ideas for this.
Thanks