[Saxmanick2013]

0

Hi guys,

Ok here it goes. I have for quite sometime a NO CA error. I have tried using Optiflash to solve the problem. The Optiflash, when used in advanced mode, it sees COM Port 7. In normal mode my DBox IP is 192.168.1.39.

When I ping, via windows command prompt, it sees the Dbox.

My Dbox is connected via RS232 DB9 to USB and Ethernet Cable.

After setting the Optiflash to communicate with the Dbox via advanced setting, the message Power on DB Device shows up and the process of repair does not happen.

Alternatively, I have tried using NCF software via an old Lap Top using Windows 2000 Server. Again the same problem, they just don't communicate.

I am about to purchase another Dbox in order to sort out the problem as I am at my wits end LOL and can't solve the problem.

I have another question. I do have a second Dbox that I use for spares if need be. Will swapping the SIM 2.01 from this old Dbox to the new one solve the NO CA issue?

Thanks

Nick

[fairbird]

0

Read this to know how to fix your box...
[Only registered and activated users can see links You are not allowed to view links. Register or Login to view.]
or
[Only registered and activated users can see links You are not allowed to view links. Register or Login to view.]
or
[Only registered and activated users can see links You are not allowed to view links. Register or Login to view.]

About change sim, yes you can:
Here how to change sim to another one:
1-leave old sim on box
2-flash new image to box for new sim
3-tune power off from box
4-NOW remove old sim and replace new one
5-tunr power on and enjoy with new sim...

[Saxmanick2013]

0

Hi fairbird....thanks for your comments.

My Dbox is genuine....i need LD2.....where can I donate for key?

Thanks

[fairbird]

0

[Only registered and activated users can see links You are not allowed to view links. Register or Login to view.]