02-07-2016, 04:48 PM
-DM800hd se
-Clone (Sunray)
-SIM A8P
-No ca found
Hello, this is my first thread.
First of all I apologize for my bad English.
I will try to explain my problem.
I have a deco Sunray SR4 sim A8P with Openpli 4 image everything was fine until yesterday.
Yesterday I installed this plugin:
enigma2-plugin-extensions-iptvplayer_98.00.05.00_all.ipk
Rebooting appeared an error green screen and crashed to about 50 %.
I turned it off by rear panel twice.
At the second rebooting the box said "Image 2nd failed" and after that all is black.
Inside the deco I can see only three red leds placed under the tuner.
I tried to use all the applications that I found on the web but the decoder does not respond.
I know the IP address of the deco but it doesn't work.
I pulled out and cleaned the sim.
On my PC I have win10 so I installed the correct drive to use a mini usb cable. When I insert the mini USB in the receiver the computer recognizes it and assigns COM3 but using different application even though I set the correct COM3 nothing happens.
Any help to revive my box would be highly appreciated !
Thank you in advance
-Clone (Sunray)
-SIM A8P
-No ca found
Hello, this is my first thread.
First of all I apologize for my bad English.
I will try to explain my problem.
I have a deco Sunray SR4 sim A8P with Openpli 4 image everything was fine until yesterday.
Yesterday I installed this plugin:
enigma2-plugin-extensions-iptvplayer_98.00.05.00_all.ipk
Rebooting appeared an error green screen and crashed to about 50 %.
I turned it off by rear panel twice.
At the second rebooting the box said "Image 2nd failed" and after that all is black.
Inside the deco I can see only three red leds placed under the tuner.
I tried to use all the applications that I found on the web but the decoder does not respond.
I know the IP address of the deco but it doesn't work.
I pulled out and cleaned the sim.
On my PC I have win10 so I installed the correct drive to use a mini usb cable. When I insert the mini USB in the receiver the computer recognizes it and assigns COM3 but using different application even though I set the correct COM3 nothing happens.
Any help to revive my box would be highly appreciated !
Thank you in advance