InfoServ

Hi,

Hope someone can help me here. Tried everything i read on the fora and unfortunately nothing helped. Tool is telling me the flashing was succesfull.
When I look into DM800 through hyperterminal i get the following error messages:



© 2007,2008 Dream Multimedia GmbH. All rights reserved.
Dreambox DM800
FIRST STAGE 1.00 {BO23456}

2ND STAGE OK, build #84 (2011-09-02)

0.000 - BCM board setup
{00000126,00000126,00000125,00000124,00000123,00000133}
0.007 - fp init
0.008 - ca init
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
CA invalid
OLED found!
NO CONFIGURATION DATA PRESENT. STOP.
lcd: * ERR01: NO CA FOUND




© 2007,2008 Dream Multimedia GmbH. All rights reserved.
Dreambox DM800
FIRST STAGE 1.00 {BO23456}

2ND STAGE OK, build #84 (2011-09-02)

0.000 - BCM board setup
{00000126,00000126,00000125,00000124,00000133,00000133}
0.007 - fp init
0.008 - ca init
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
CA invalid
OLED found!
NO CONFIGURATION DATA PRESENT. STOP.
lcd: * ERR01: NO CA FOUND

What can I do about this?

Thanks in advance, Mojo

Please read that thread what yassinov mentioned and put your thread in right section ..

Closed...not followed thread