+- InfoServ (https://www.yassinov.com/forum)
+-- Forum: Satellite Equipment (https://www.yassinov.com/forum/forumdisplay.php?fid=9)
+--- Forum: Dreambox OptiFlasher Pro [Basic EDition] (https://www.yassinov.com/forum/forumdisplay.php?fid=35)
+--- Thread: Still getting error after flashing the DM800 clone (/showthread.php?tid=1116)
Still getting error after flashing the DM800 clone - mojitsu - 09-30-2012
Hi,
Hope someone can help me here. Tried everything i read on the fora and unfortunately nothing helped. Tool is telling me the flashing was succesfull.
When I look into DM800 through hyperterminal i get the following error messages:
© 2007,2008 Dream Multimedia GmbH. All rights reserved.
Dreambox DM800
FIRST STAGE 1.00 {BO23456}
2ND STAGE OK, build #84 (2011-09-02)
0.000 - BCM board setup
{00000126,00000126,00000125,00000124,00000123,00000133}
0.007 - fp init
0.008 - ca init
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
cannot read cert(2)
CA invalid
OLED found!
NO CONFIGURATION DATA PRESENT. STOP.
lcd: * ERR01: NO CA FOUND
© 2007,2008 Dream Multimedia GmbH. All rights reserved.
Dreambox DM800
FIRST STAGE 1.00 {BO23456}
2ND STAGE OK, build #84 (2011-09-02)
0.000 - BCM board setup
{00000126,00000126,00000125,00000124,00000133,00000133}
0.007 - fp init
0.008 - ca init
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
SW != 9000
error in receive
error during t1 transfer
cannot read cert(1)
CA invalid
OLED found!
NO CONFIGURATION DATA PRESENT. STOP.
lcd: * ERR01: NO CA FOUND
What can I do about this?
Thanks in advance, Mojo
RE: Still getting error after flashing the DM800 clone - fairbird - 10-01-2012
Please read that thread what yassinov mentioned and put your thread in right section ..
RE: Still getting error after flashing the DM800 clone - fairbird - 10-10-2012
Closed...not followed thread